User guide
Table Of Contents
- For Your Records
- Getting Started
- Package Contents
- Important Safety Warnings
- Connect Input and Output Devices
- Installation Steps
- Adjusting the Projector Angle
- Projector Placement Distance
- Using The Projector
- Control Buttons
- OnView Indicators
- Setup Main Menu
- Input Menu
- Image Menu
- Options Menu
- Other Information
- Specifications
- Timing Chart
- Troubleshooting
- Power Indicator Lights
- Screen Messages
- Maintenance
- Lamp Replacement
- Installing Battery (for remote control)
- Cleaning Instructions
- Air-Filter
- Customer Support
- LIMITED WARRANTY
- VIEWSONIC Projector
- Appendix
- Power Cord Safety Guidelines
- FCC Information
ViewSonic PJ853 10
E
N
G
L
I
S
H
Options Menu
Blank
selects the background color of a blank screen. You may select a blank
screen, or a blank screen will be projected when no input source is detected.
Mirror
Select
Normal
for a table top projection.
Select
H: Invert
for rear projection.
Select
V: Invert
for a front projection ceiling mount.
Select
H&V: Invert
for a rear projection ceiling mount.
Start up
selects a start-up menu. You may select or deselect the ViewSonic
Welcome menu to display automatically at start-up.
OPTIONS Menu
The Options menu displays 6 options that are explained below:
Volume
increases or decreases the volume.
Menu Color
selects a background color for on screen menus (Orange, Yellow,
Green, Blue, Purple, Gray, Black).
Timer
provides a countdown clock that you can set, typically used to time a
presentation.
Set the countdown Timer between 1 and 99 minutes. The time will display on the
lower right portion of the screen when you press the Timer button on the remote
control.
Language
selects a menu-display language from a list.
Auto Off
Causes the projectorto automatically enter astandby, cool-down mode
after a specified amount of time has elapsed without a signal.
SYNCon G
Synchronize on Green.If you know that you are usinga SYNC ON
G input device set SYNC ON G to “ON,” otherwise, leave SYNC ON G set at its
default value which is “OFF.”