User guide
Table Of Contents
- For Your Records
- Getting Started
- Package Contents
- Important Safety Warnings
- Connect Input and Output Devices
- Installation Steps
- Adjusting the Projector Angle
- Projector Placement Distance
- Using The Projector
- Control Buttons
- OnView Indicators
- Setup Main Menu
- Input Menu
- Image Menu
- Options Menu
- Other Information
- Specifications
- Timing Chart
- Troubleshooting
- Power Indicator Lights
- Screen Messages
- Maintenance
- Lamp Replacement
- Installing Battery (for remote control)
- Cleaning Instructions
- Air-Filter
- Customer Support
- LIMITED WARRANTY
- VIEWSONIC Projector
- Appendix
- Power Cord Safety Guidelines
- FCC Information
ViewSonic PJ853 16
E
N
G
L
I
S
H
Installing Battery (for remote control)
• Use a 3V micro lithium battery as shown in the illustration.
• The battery is not rechargeable.
1
Pull the plastic tab from the battery access door when using the new projector for the first time.
2
Pinch the battery holder at the bottom of the remote control and gently pull out the holder with
the battery.
3
Gently pop the battery out of the holder and replace it with a new battery.
4
The + side of the battery should be facing up as shown in the illustration.
5
Push the battery and holder back into the battery slot. The holder should click into place.
Cleaning Instructions
Projector Lens
• Clean the lens with a damp, non-abrasive cloth. Apply a lens cleaning solution or a glass cleaning
solution to the cloth. Do not spray a cleaning solution directly onto the lens.
Projector Case
• Make sure the projector is cool before cleaning.
• Clean the exterior case with a moist cloth using a mild detergent.
WARNING:
Do not use alcohol, benzene, or other chemical cleaners which could damage the case.
Figure 9: Installing the Battery
Pull out
“+” side
Battery Holder
PJ853-.book Page 16 Wednesday, August 16, 2000 11:41 AM