User guide
Table Of Contents
- For Your Records
- Getting Started
- Package Contents
- Important Safety Warnings
- Connect Input and Output Devices
- Installation Steps
- Adjusting the Projector Angle
- Projector Placement Distance
- Using The Projector
- Control Buttons
- OnView Indicators
- Setup Main Menu
- Input Menu
- Image Menu
- Options Menu
- Other Information
- Specifications
- Timing Chart
- Troubleshooting
- Power Indicator Lights
- Screen Messages
- Maintenance
- Lamp Replacement
- Installing Battery (for remote control)
- Cleaning Instructions
- Air-Filter
- Customer Support
- LIMITED WARRANTY
- VIEWSONIC Projector
- Appendix
- Power Cord Safety Guidelines
- FCC Information
ViewSonic PJ853 6
E
N
G
L
I
S
H
Using The Projector
The control buttonsdisplaymenusthat are explained in detailin the section: “OnViewIndicators” on
page 8.
Control Buttons
Press a control button to display a menu then use the arrow buttons to adjust the control. The buttons
on the projector control pad and on the remote control are explained below:
Figure 7: Projector and Remote Controls
Standby/on Button
Press the STANDBY/ON button to begin the warm-up period. The ON indicator
blinks green during warm-up and stays green when the projector is ready to use.
NOTE:
Theprojector cannot be restarted within60 seconds after it isturned off because
the projector enters a cool-down mode. This is a safety feature.
Input Button (Video and RGB Buttons)
The INPUT button shown is on the projector only. Use the Video and RGB buttons on
the remote control to select the input source.
Press the Input button on the projector to toggle between input sources, computer
(RGB), Composite or S-Video. The remote control has both a Video and an RGB
button.
-
Press RGB to select a computer as the input source.
-
Press Video to toggle between Composite and S-Video.
Projector control pad
Remote control
PJ853-.book Page 6 Wednesday, August 16, 2000 11:41 AM