User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
27
Changing HDMI input settings
In the unlikely event that you connect the projector to a device (such as DVD or
Bluray player) via the projector’s HDMI input jack, and the projected picture displays
the wrong colors, please change the color space settings to one that complies with
the color space settings of the output device.
To perform this operation:
1. After the signal source is connected, press the [Setting] key and enter the Advanced
> HDMI Setting menu.
2. Press [Enter].
3. Select Range, then press / to select a suitable color range according to the color
range settings of the output device.
● Full: Changes HDMI color range to 0-255.
● Limited: Changes HDMI color range to 16-235.
● Auto: Sets the projector to automatically detect the HDMI range of the input signal.
This function is only available when the HDMI input jack is being used.
Please refer to equipment documentation to gain more details on color space and HDMI range
settings.