User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
29
Perform keystone correction
Keystone distortion is a problem where the projected image becomes trapezoidal in shape
(keystone distortion) as a result of poor projection angle.
To correct this situation, you should adjust projector height and use the following steps to
correct the issue manually.
● Using the remote control
1. Press / to display the Keystone Correction page.
2. Press to initiate Keystone Correction at the top of the image. Press to initiate
Keystone Correction at the bottom of the image.
● Using the OSD menu
Open the OSD menu and open Basic Settings > Keystone menu.
Adjust values: -40-40