User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
34
Adjust Gamma
Enter Image Setting > Gamma menu then press
/
and adjust the value.
1.8 / 2.0 / 2.2 / 2.35 / 2.5 / sRGB / Cubic, respectively, represent the different gray scale
curves.
This function is only available when the input signal is video.
Adjusting Brilliant Color
Enter Image Setting > Brilliant Color menu and press /.
This feature utilizes a new color-processing algorithm and system level
enhancements to enable higher brightness while providing truer, more vibrant
colors of the projected image. Brightness levels of mid-tone areas commonly
seen in videos and natural landscapes are increased by more than 50%,
allowing the projector to generate images in realistic and true colors. To acquire
this quality of images, please select the level you desire. If not required, set this
option to Off.
Red
Yellow
Green
Cyan
Blue
Magenta
Reducing image noise
Enter Image Setting > Noise Reduction menu, and then press /.
This function is capable of reducing image noise generated electrically by different media
players. Higher settings will provide lower image noise.
This function is only available when PC, Video input signals are selected.