User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
36
Fine-tuning of image in user modes
If the projector detects specic types of signals, you can use several customized
functions. You can adjust these functions as necessary.
Adjusting Digital zoom
Enter Image Setting > Digital Zoom menu and press / to adjust the value.
Adjust the option to zoom in or out the image.
Adjusting Position
Enter Image Setting > Position menu and press / to adjust the value.
Show Position adjustment page. Use the arrow keys when moving the projected
images. Each time the key is pressed, the value displayed in the bottom half of the
page will change accordingly, until the maximum or minimum.
This function is only available when the PC input signal is selected.
The adjustment range may vary at different time sequences.
Adjusting Phase
Enter Image Setting > Phase menu and press / to adjust the value.
Adjust the clock phase to reduce image morphing.
This function is only available when the PC input signal is selected.
Adjusting Horizontal size
Enter Image Setting > H. Size menu and press / to adjust the value.
Adjust the option to change the horizontal width of the image.
This function is only available when the PC input signal is selected.
Adjusting Overscan
Enter Image Setting > Overscan menu and press / to adjust the value.
To prevent an image from partially becoming deformed at the screen edges, the
overscan technology has been employed to enlarge the image by 5% or even 10%
and extend the deformed image beyond the screen to display only the middle part
with good linearity.