User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
39
Control the projector through the local area network
This projector supports Crestron
®
software. After correct settings in the wired local area
network menu are nished, the projector can be managed on the computer with the
browser when the computer and the projector are correctly connected to the same local
area network.
(Example of connection)
Congure the wired local area network
If you are in a DHCP environment:
1. Connect one end of the RJ45 cable to the RJ45 local area network input jack of the
projector, and connect the other end to the RJ45 port.
2. Open the OSD menu and enter the Network Settings.
3. Select DHCP and then press / to select On.
4. Press to select the Apply and then press [Enter].
5. Please wait for about 15-20 seconds and then re-enter the page of the wired local
area network. The IP address, subnet mask, default gateway and DNS server
settings will be displayed. Please remember the IP address displayed in the IP
address.
If the IP address still does not display, contact the network administrator.
If the RJ45 cable is not correctly connected, the IP address, subnet mask, default gateway and
DNS server settings will be displayed as 0.0.0.0. Make sure the cable has been correctly
connected and re-execute the above steps.
To connect to the projector when the projector is in the standby mode, set the Network Settings
> Wired LAN > Standby LAN Control to On.