User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
40
If you are in a non-DHCP environment:
1. Repeat the above steps 1-2.
2. Select DHCP and then press / to select Off.
3. Contact your ITS administrator for the setting information about IP address, subnet
mask, default gateway and DNS server.
4. Press to select the item you want to modify and then press [Enter].
5. Press / to move the cursor and then press / to input the value.
6. To save the settings, press [Enter]. If you do not want to save the settings, press [Exit].
7. Press to select Apply and then press [Enter].
If the RJ45 cable is not correctly connected, the IP address, subnet mask, default gateway and
DNS server settings will be displayed as 0.0.0.0. Make sure the cable has been correctly
connected and re-execute the above steps.
To connect to the projector when the projector is in the standby mode, make sure the DHCP has
beens set to Off and the IP address, subnet mask, default gateway and DNS server information
have been acquired after the projector is powered on.
Control the projector with the web browser
If the correct IP address of the projector is acquired, and the projector is powered
on or in standby mode, any computer in the same local area network can be used to
control the projector.
If Microsoft Internet Explorer is used, make sure the version is 7.0 or higher.
The screenshots in this manual are for reference only. Actual OSD design may differ.
1. Enter the address of the projector in the address bar of your browser and press [Enter].
2. The homepage of “Network Control” is displayed.
5
4
3
Access to the Network Settings or Email Alert web page needs the administrator password. The
default password is “0000”.