User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
41
3. You can adjust AMX and SNMP settings on this page. On the AMX device discovery,
the controller connected to the AMX of the same network will nd the projector when
ON is selected. For details of the AMX Device Discovery, please access the AMX
website: http://www.amx.com/.
4. If the projector is connected to the network which supports the SMTP (Simple Mail
Transfer Protocol), you can congure it to send alarms via emails when important
events occur.
5. Crestron (e-Control) page displays the Crestron e-Control user interface. For details,
please refer to “About Crestron e-Control®”.