User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
42
Please note the input length limits in the following table (including space and other
punctuation marks):
Type item Input length Maximum character
Network Settings
Network
DHCP/Manual (None)
IP Address XXX.XXX.XXX.XXX
Subnet Mask XXX.XXX.XXX.XXX
Gateway XXX.XXX.XXX.XXX
DNS Server XXX.XXX.XXX.XXX
AMX device discovery (None)
Password
Administrator (None)
New Password 4
Conrm Password 4
SNMP
SysLocation 22
SysName 22
SysContact 22
Email Alert
Email Setting
To 40
Cc 40
Subject 40
From 40
SMTP Setting
Server 30
User Name 21
Password 14
Alert Condition
Fan Error (None)
Light source Error (None)
Over Temperature (None)
Light source Time Alert (None)
Submit (None)
Issue Test Mail (None)
/ > < $ % + \ ‘ “ are forbidden.