User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
43
About Crestron e-Control
®
1. The Crestron e-Control
®
page provides various virtual buttons to control the projector
or adjust the projected image.
i
i
i
ii
You can press
/
to display
more buttons.
i. The functions of those buttons are identical with those on the OSD menu or
remote control.
ii. To switch the input signal source, please click the required signal.
The Menu button can be used to return to the previous OSD menu, exit and save menu settings.
The signal source list may differ from the available interfaces on the projector.
The web browser needs some time to perform change synchronization with the projector when
the projector control panel or remote control is used to change the OSD menu settings.
2. The Tools page can be used to manage the projector, congure the LAN control
settings, and perform remote network operation security access to the projector.
i iv
iii
ii
v
vi
i. This part can be used only in the case that the Crestron control system is used.
Please contact Creston or refer to its user guide to get a knowledge of the
installation information.
ii. You can name the projector, and record its position and responsible person.