User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
44
iii. You can adjust the wired local area network.
iv. After setup has nished, the remote network operation access to the projector is
protected with a password.
v. After setup has nished, access to the Tools page is protected with a password.
To avoid mistakes, please input the English letters and digits in the Tools page.
After adjustment, press the Send button and the data will be saved in the projector.
vi. Press [Exit] and then you can return to the remote network operation page.
Please note the input length limits in the following table (including space and other
punctuation marks):
Type item Input length Maximum character
Crestron Control IP Address 16
IP ID 4
Port 5
Projector Projector Name 32
Location 32
Assigned To 32
Network Conguration DHCP (Enabled) (None)
IP Address 16
Subnet Mask 16
Default Gateway 16
DNS Server 16
User Password Enabled (None)
New Password 26
Conrm 26
Admin Password Enabled (None)
New Password 26
Conrm 26
3. The Info page displays the information and status of this projector.
Press [Exit] and then you
can return to the remote
network operation page.