User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
47
Menu operations
Menu system (When not connected to signal source)
Please note that the on-screen display (OSD) menu may vary according to the type of
signal received.
The projector must detect at least one valid signal in order to use the menu items. If no
device has been connected to the projector or if no signal has been detected, only a few
menu items will be accessible.
Main menu Sub-menu Options
1.
Basic Settings
Language
Audio settings
Mute On/Off
Audio Volume 0~20
Power On/Off Ring Tone Off/On
Projector Projection
Front Table / Front Ceiling/
Rear Table/ Rear Ceiling
Keystone -40~40
Pattern Off/Test Card
Remote Control Code 1/2/3/4/5/6/7/8
Baud rate
115200/2400/4800/9600/14400/
19200/38400/57600
2.
Network
Settings
Wired LAN
Congure IP
Auto / Manual
IP Address 0.0.0.0
Subnet Mask 0.0.0.0
Default Gateway 0.0.0.0
DNS Server 0.0.0.0
Standby LAN Control Off/On
3.
Advanced
Settings
Power On Source
Home/HDMI1/HDMI2/VGA1/
VGA2
Auto Power On
Direct Power On Disable/Enable
Signal Disable/VGA1/HDMI1/All
CEC Disable/Enable
Smart Energy
Auto Power Off
10 min/ 20 min/ 30 min/
Disable
Sleep Timer
30 min/ 1 hr/ 2 hr/ 3 hr/ 4 hr/
8 hr/ 12 hr/Disable
Power Saving Disable/Enable
Light Source Mode Normal 100% / Eco 80%
High Altitude Mode
Off
On Yes/Cancel
Reset All Settings Yes/Cancel