User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
49
Menu system (When connected to signal source)
6.
Image Setting
Color Mode
Movie/Sports/Gaming/User 1/
User 2/Brightest/Standard
Brightness 0~100
Contrast -50~50
Color Temp
7500K/9300K/User/
6500K
·Red gain 0~199
·Green gain 0~199
·Blue gain 0~199
Tint -99~99
Saturation 0~199
Sharpness 0~31
Gamma
1.8/2.0/2.2/2.35/2.5/
sRGB/Cubic
Brilliant Color 1/2/3/4/5/6/7/8/9/10/Off
Noise Reduction Off / Low / Mid / High / Auto
Color Management
·Primary Color R/G/B/C/M/Y
·Hue -99~99
·Saturation 0~199
·Gain 5~195
Digital Zoom 0.8x~2.0x
Position
X -5~5
Y -5~5
Phase 0~100
H. Size -15~15
Overscan Off/1/2/3/4/5
Reset Current Color Settings Reset/Cancel
7.
Advanced
Aspect Ratio 16:9/16:10/Native/Auto
HDR Auto/SDR
EOTF Low / Mid / High
Frame Interpolation Off / Low / Mid / High
HDMI Setting Range Limited / Auto / Full
3D Settings
3D Format
Off / Frame Sequential /
Frame Paking / Top-Bottom /
Side-by-Side / Auto
3D Sync Invert Invert / Disable
Save 3D Settings
Information
·Source
·Resolution
·3D Format
·HDR