User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
50
Description of menu
Functions Description
1. Basic Settings
Language
Set language of the display screen (OSD) menu.
Please refer to “Activate the projector” for the details.
Audio settings
Mute
Audio Volume
Power On/Off Ring Tone
The will be a tone prompt when the projector is
powered on or off.
Projector Projection Please refer to “Choosing a location” for the details.
Keystone
Please refer to “Perform keystone correction” for the
details.
Pattern
The projector can display a test pattern. It can help you
adjust the image size and focal length to ensure that
there is no distortion of the projected images.
Remote Control Code Please refer to the “IR control table” for the details.
Baud rate
Please refer to the “RS232 command table” for the
details.
2. Network Settings
Network Settings Please refer to the “Network Settings” for the details.
3. Advanced Settings
Power On Source
Please refer to the “Switching input signal” for the
details.
Auto Power On
Signal
Set whether or not the projector will automatically adjust
when it is in standby mode and detects VGA or HDMI
signals of 5V power supply.
CEC
Please refer to “Using the CEC function” for the details.
Direct Power On
Once the power is supplied via power cord, the
projector can turn on automatically if “Enable” has
been selected.