User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-Control®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
56
Specications
Projector specications
● All specications are subject to change without notice.
● Not all projector models are available at your location.
Input Terminals
1 VGA input (DB 15 pin) x2
2 HDMI (v1.4 with audio) x2
3 Video (RCA) x1
4 Audio input (3.5mm mini jack) x1
Output Terminals
1 Audio output (3.5mm mini jack) x1
2 USB-A 5V/1.5A x1
3 Speaker x1
4 VGA output x1
Control Terminals
1 RS232 (9 pin 1 type) x1
2 USB cable (mini B type) x1
3 LAN x1
Fuse specications
The fuse number used on the power PCB board is: F1, and the specifications are: 250V,
T6.3AH