User Guide
Table Of Contents
- Key safety instructions
- Introduction
- Projector Positioning
- Connection
- Operation
- Activate the projector
- Using the menus
- Use basic settings
- Use Network setting
- Use Advanced settings
- Use Information
- Use Firmware upgrade
- Use Image settings
- Use Advanced settings (in signal source mode)
- Switching input signal
- Changing HDMI input settings
- Adjusting the projected image
- Perform keystone correction
- Using the CEC function
- Smart energy-saving
- Light Source Mode
- Operations at high altitudes
- Hiding the image
- Optimize images in user mode
- Fine-tuning of image quality in user modes
- Adjust Gamma
- Color Management
- Fine-tuning of image in user modes
- Select the aspect ratio
- About the aspect ratio
- Control the projector with the web browser
- About Crestron e-ControlĀ®
- Using the projector under standby mode
- Switch off the projector
- Menu operations
- Maintenance
- Troubleshooting
- Specifications
- Copyright information
- Appendix
64
62
5962
Address Code
Code 1 83F4
Code 2 93F4
Code 3 A3F4
Code 4 B3F4
Code 5 C3F4
Code 6 D3F4
Code 7 E3F4
Code 8 F3F4
RS232 command table
<Pin assignment for this two end>
Pin Description Pin Description
1 NC 2 RX
3 TX 4 NC
5 GND 6 NC
7 RTSZ 8 CTSZ
9 NC
<Interface>
RS-232 protocol
Baud Rate 115200bps (default)
Data Length 8 bit
Parity check None
Stop bit 1 bit
flow control None