User guide

ENGLISH

ViewSonic N2630w/N3230w/N3730w

TV Controls

Front View of LCD Set

TV Inputs(Side)

1. LED indicator lamp

2. Remote Sensor

3. VOLUME+/VOLUME

4. CHANNEL+/CHANNEL

5. MENU

6. Source

7. Power

To turn the TV power ON

Put the TV where it can be easily viewed, connect the power plug of AC voltage at the back of the TV set,

the LED indicator lamp turns red, then press the Power key. When the LED indicator lamp turns to blue,

the TV set power is on. It takes a few seconds before the picture appears.

To turn the TV power OFF

Press the Power key to make the TV go into the Standby Mode, disconnect the power plug from the wall

outlet.

NOTE

The TV will automatically enter into the standby mode, if the TV has not a signal input and no function is

performed for 5 minutes except that the input source of the TV is HDTV. If you are not going to use this

TV set for a long time, turn off the set and disconnect the power plug from the wall outlet.

When the user presses MENU or Source key, it enters a MENU or source MENU. The user can press

CHANNEL+/CHANNEL- to move the cursor up/down and press VOLUME+/VOLUME- selects a

parameter to increase/ decrease. Pressing Source to conrm which is the same as “Enter”on the remote.

2 1