User Guide

5. Press / to move the cursor and the press / to enter the value. You can also

use the numeric buttons on the remote control to enter the value.

6. To save the settings, press Enter. If you do not want to save the settings, press Exit.

7. Press to highlight Apply and press Enter.

If the RJ45 cables are not properly connected, the Projector IP Address, Subnet Mask, Default

Gateway, and DNS Server settings will display 0.0.0.0. Make sure the cables are properly

connected and perform the procedures above again.

If you wish to connect to the projector in its standby mode, be sure you have selected Static IP

and obtained the Projector IP Address, Subnet Mask, Default Gateway, and DNS Server

information when the projector is on.

Controlling the projector through a web browser

Once you have the correct IP address for the projector and the projector is on or in standby

mode, you can use any computer that is on the same local area network to control the

projector.

If you are using Microsoft Internet Explorer, make sure it is version 7.0 or higher.

The screen shots in this manual are for reference only, and may differ from the actual design.

1. Enter the address of the projector in the address bar of your browser and press Enter.

2. The main page of the Network Control appears.

Accessing to Network Settings or Email Alert page requires Administrator password. The

default password is "0000".

3. This page allows you to make adjustments to the AMX and SNMP settings. In the

AMX device discover row, when ON is selected, the projector can be detected by