User Guide

Mirroring contents from your smart device

1. Switch the input signal to USB Display.

2. The following image will be displayed.

3. Connect one end of the USB cable to the USB READER socket on the projector and

the other end to your smart device.

4. Open the vPresenter Pro (available on application stores) on your smart device and

start mirroring.

Shutting down the projector

1. Press Power or Off and a confirmation

message is displayed prompting you.

If you don't respond in a few seconds, the

message will disappear.

2. Press Power or Off a second time.

3. Once the cooling process finishes, a "Power

Off Ring Tone" will be heard. Disconnect the

power cord from the wall socket if the

projector will not be used in an extended

period of time.

• To turn off the ring tone, see "Turning off the Power On/Off Ring Tone" on page 42 for

details.

• If you need to connect to the projector in standby mode, set Wake On Lan to On in the

ADVANCED > LAN Control Settings menu. Then use a WOL tool to activate the standby

network function.

CAUTION

• To protect the lamp, the projector will not respond to any commands during the cooling

process.

• Do not unplug the power cord before the projector shutdown sequence is complete.