Operation Manual

Replacing the lamp

To prepare a new lamp, contact your dealer and tell the lamp type number.

Type number:

WARNING

Hg - Lamp contains mercury. Manage in accordance with local disposal

laws. See www.lamprecycle.org

• To reduce the risk of electrical shock, always turn the projector off and disconnect the

power cord before changing the lamp.

• To reduce the risk of severe burns, allow the projector to cool for at least 45 minutes

before replacing the lamp.

• To reduce the risk of injuries to fingers and damage to internal components, use caution

when removing lamp glass that has shattered into sharp pieces. Before replacing the

lamp, clean the lamp compartment and dispose of cleaning materials. Be careful of sharp

edges in the lamp compartment. Wash hands after lamp replacement.

• Only ViewSonic certified lamps are tested with this projector. Use of other lamps may

cause electrical shock and fire.

1. Turn the power off and disconnect the

projector from the wall socket. If the

lamp is hot, avoid burns by waiting for

approximately 45 minutes until the

lamp has cooled.

2. Loosen the screws that secure the lamp

cover on the both sides of the projector

until the lamp cover loosens.

3. Remove the lamp cover from the

projector.

WARNING

• Do not turn the power on with the lamp

cover removed.

• Do not insert your fingers between the

lamp and the projector. The sharp edges

inside the projector may cause injuries.

4. Remove and dispose of the lamp

protection film.

Type number:

RLC-070

PJD5226w/PJD6223/PJD6353/PJD6353s/PJD6653w/PJD6653ws

RLC-077

PJD5126/PJD5226

RLC-071

PJD6253/PJD6383/PJD6383s/PJD6553w/PJD6683w/PJD6683ws