User Guide

Operation

Activate the projector

Plug the power cord into the projector and into a wall socket. Turn on the switch on the

wall socket (if available).

Press

Power to switch on the projector.

If this is the rst time that you've switched on the projector, please refer to on-screen

instructions and select your OSD language.

Switch on all connected equipment.

The projector will then begin a search of the input signals. The lower right corner of the

screen will display the current input signal being scanned. If the projector fails to detect a

valid signal, the screen will display a [NO SIGNAL] message until an input signal is found.

You can press "Source" to select the input signal required. See “Switching input signal” for

details.

If the input signal frequency / resolution is outside the operating range of the projector, the

blank screen will display the [Out of Range] message. Please change to an input signal which is

compatible with the projector's resolution or set the input signal to a lower setting. For more

details, please refer to the [Resolution Table].

Using the menus

This projector has an on-screen display (OSD) menu function that allows you to

change different settings.

The following OSD screenshot is for reference only. Actual OSD design may differ.

The following is an overview of the OSD menu.

Main menu icon

Status

Select

Sub-menu

Press “MENU” to

go back to the

previous window

or toexit.