Manual

WMK-005

Installation Manual Page - 15 -

Securing the Projector to the Upper Assembly

1. Make sure the three-knurl knobs are loosened to fully expose to the “tri-lock” mounting plate in the

base of the upper assembly.

2. Carefully lift the projector and insert the mounting bracket mating special tri-lock cutout into the

mating portion of the upper assembly.

3. Once inserted rotate the projector and mounting bracket 180° and secure the rear safety knob first to

prevent further rotation of the bracket in the upper assembly.

4. Tighten the remaining two tension knurl knobs until the mount becomes rigid. The safety knob

should line up with the alignment slot on the mounting bracket.

Figure 7. Low Profile Installation

NOTE: Follow the numbering

sequence prior to securing

the projector to the upper

assembly.

The alignment slot

must be in direct

alignment with the

safety knob to lock

the mounting

bracket to the

upper assembly.

Universal Mount

Tri-Lock

Opening

Alignment Slot

Safety Knurl Knob

Tension Knurl Knobs

Insert universal bracket to

the tri-lock, then rotate the

projector 180°

Projector