Manual

WMK-005
Page - 16 - Installation Manual
Final Adjustments
1. With the projector secured in the mount and power on and signal supplied to the projector you can
now proceed with the final height, tilt, roll and yaw to optimize the projected image.
Figure 8. Final Adjustments
A
The height can be adjusted by slightly
loosening the two 8mm height adjustment
screws and raising/lowering the projector.
Once the height is achieved, tighten the
screws.
B
To adjust the tilt angle of the projector,
slightly loosen the side M8 screws and tilt
to the desired angle and firmly tighten the
two M8 adjustment screws.
C
If roll adjustment is needed to square the
images on the screen, slightly loosen the
front and rear M8 screws and adjust to
the desired angle. Then firmly tighten the
two M8 adjustment screws.
Re-check the hardware for tightness and security.
Allen Wrench
W
ooden Stud
Ceiling Structure
Height Adjustable
Screws
W
ooden Stud
Ceiling Structure
Tilt Adjusting Screws
Allen Wrench
C
B
A
W
ooden Stud
Ceiling
Structure
Allen Wrench
(Roll) Adjusting
Screws