Installation guide
3/4”
(1.9 cm)
End panel
1”
(2.5 cm)
1/4”
(0.6 cm)
Z-Bracket
2
1
-
3
/
4”
(
5
5
.
2 c
m
)
21-3/
4
”
(
55
.
2
c
m
)
2
4”
(
61
.0
c
m)
Optional kickplate notch
(Dimensions determined by cabinets)
24”
(61
.0 c
m)
82-7/8”
(21
0
.
5
c
m
) min
.
t
o
84-1/
16”
(
2
1
3
.
5
c
m
)
max
.
*
8
2
-7/8
”
(21
0
.
5
cm
) min
.
to
8
4
-1/
1
6”
(
2
1
3
.
5
cm)
m
ax.
*
Custom Side Panel Dimensions
49
48
*Note: Depending on how high leveling feet are raised, and cabinet enclosure height.
Custom Panel General Information
Custom finishing options
• All installations must allow for the refrigerator
and freezer door to open a minimum of 90˚.
• For side wall or corner installation, allow for a
standard 3” (7.6 cm) cabinet filler to assure
door(s) opens 90˚.
Note: If a custom handle is used, a wider filler
may be necessary.
• Panel thickness must not exceed 1” (2.5 cm)
on hinge side. Thicker panels will interfere with
door swing and clearance.
Ice and Water Dispenser Bezel Removal (if required)
Note: Designer model shown.
Remove packaging material surrounding bezel.
Grasping the sliding lever, pull away from bezel.
Remove spill tray from lower part
of bezel exposing 2 screws.
Remove screws.
1
2
4
3
Note: Adding 3/4”
(1.9 cm) side panels adds
an additional 3/4” (1.9 cm)
to the overall width of
the product for each
side panel used.
Note: Requires side panel
hardware kit (SPHKDS).