Installation Guide

22
Changing The Water and Air Filters
Your refrigerator is equipped with separate water and air
fi ltering systems. The water fi lter system fi lters all the water
used to produce ice. The air fi lter removes odors and
impurities from the refrigerator compartment.
NOTE
When ordering your replacement fi lter, please reorder the
same fi lter type that is currently in your refrigerator.
About your advanced water fi lter
The ProChill fi lter system is tested and
certifi ed by NSF International to NSF/ANSI
Standards 42, 53 and 401 for the reduction
of claims specifi ed on the performance data
sheet.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or
after the system. Systems certifi ed for cyst reduction may
be used on disinfected waters that may contain fi lterable
cysts.
• Rated Capacity - 125 gallons/473 liters
• Rated service fl ow - .65 gallons per minute
• Maximum Rated Pressure - 100 pounds per square
inch
• Recommended Minimum Operating Pressure: 30
pounds per square inch
• Operating Temp.: Min. 33°F, Max. 100°F
Water fi lter
The water fi lter is located at the top right side of the fresh
food compartment.
Replacing your ProChill water fi lter
In general, you should change the water fi lter every six
months to ensure the highest possible water quality. The
Water Filter Status light on the Touch Panel prompts you
to replace the fi lter after a standard amount of water (125
gallons/473 liters) has fl owed through the system.
If your refrigerator has not been used for a period of time
(during moving for example), change the fi lter before
reinstalling the refrigerator.
It is not necessary to turn the water supply off to change
the fi lter. Be ready to wipe up any small amounts of water
released during the fi lter replacement.
To replace your water fi lter
1 . Turn Off the ice maker power switch.
2. Remove the old fi lter by rotating it counter-clockwise (to
the left) 90 degrees to release it.
3. Slide the old fi lter cartridge straight out of the housing
and discard it.
Filter Cartridge
4. Unpackage the new fi lter cartridge. Slide it into the
fi lter housing as far as it will go with the grip end
horizontal.
5. Push lightly inward on the fi lter while rotating it
clockwise (to the right). The fi lter will then pull itself
inward as it is rotated. Rotate the fi lter 90 degrees until
it stops and the grip end is vertical. You may be able to
feel a very light click as the fi lter locks into place.
6. Press a drinking glass against the water dispenser
while checking for any leaks at the fi lter housing. Any
spurts and sputters that occur as the system purges
air out of the dispenser system are normal.
7. Continue dispensing water for 3-4 minutes or until 1.5
gallons of water has fl owed through the system. You
will likely need to empty and refi ll your glass several
times.
8. Turn On the ice maker.
9. Press and hold the Water Filter reset button on the control
panel for three seconds. When the display changes from Red
to Green, the status has been reset.