Owners Manual

10
Removing the Doors
Once both doors are in place, ensure they are aligned with
each other and level (please see the “Installation” section for
more details), and replace the top hinge cover.
CAUTION
Be sure doors are set aside in a secure position
where they cannot fall and cause personal injury, or
damage to the doors or handles.
To remove the refrigerator doors:
1 Trace lightly around the door’s top hinges with a
pencil. This makes reinstallation easier.
2 Disconnect the harness by grasping both sides of the
connector fi rmly, depress the latch, and pull apart.
Remove the two screws from the top hinge. Lift the
door off of the bottom hinge and set it aside.
3 Unscrew the three lower hinge screws and hinge if
Lower Hinge Removal
necessary.
Getting through narrow spaces
If your refrigerator will not fi t through an entrance area,
before installing the door handles, you can remove the
doors. Check fi rst by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord is unplugged
from the wall outlet.
2 Open the freezer drawer and remove the toe grille
(see “Installation” section).
3 Remove any food from the door shelves and close the
doors.
To remove the top hinge covers:
1 Remove the two screws from each cover over the top
door hinges.
2 Lift inside edge of hinge cover and tilt back.
NOTE
DO NOT remove the ground screw from hinge.
To reinstall the right door, reverse the above steps.