Quick Specs

TruTouch Control Sabbath Mode Removing the Doors (continued)Removing the DoorsTruTouch Control (continued)
2
3
4
5
The Sabbath Mode is a feature that disables portions of the refrigerator and its controls
for the TruTouch Control, in accordance with observance of the weekly Sabbath and
religious holidays within the Orthodox Jewish community.
Sabbath Mode is turned ON and OFF by pressing and holding the freezer temp “ - ”
and the refrigerator temp “ + ” indicators for fi ve (5) seconds. The display shows “Sb”
while in Sabbath mode.
In the Sabbath Mode, the High Temp alarm is active for health reasons. If a high
temperature alarm is activated during this time, for example due to a door left
ajar, the alarm will sound intermittently for about 10 minutes. The alarm will
then silence on its own and a red high temperature icon will display. The high
temp icon will continue to display, even if the door is closed, until the Sabbath
mode is exited and the icon reset. The refrigerator will function normally once
the door is closed, without any violation of the Sabbath/Holidays.
For further assistance, guidelines for proper usage and a complete list of models with the
Sabbath feature, please visit the web at http:\\www.star-k.org.
NOTE
During Sabbath Mode, the ice maker is turned off by main control board.
NOTE
While in Sabbath Mode, neither the lights nor the control panel will work until Sabbath
Mode is deactivated.
Refrigerator stays in Sabbath Mode after power failure recovery. It must be deactivated
with the buttons on the control panel.
Sabbath Mode and the Temperature Adjustable Cold Zone Drawer
The Temperature Adjustable Cold Zone Drawer should be turned off for the Sabbath/
Holidays. Before putting the refrigerator into the Sabbath mode, turn the Cold Zone
drawer off by pressing the drawer on/off button. The display will show “OFF” and the
drawer will turn off. Then enter the Sabbath mode function on the main refrigerator
display. See the TruTouch Control Sabbath Mode section. When in Sabbath mode, the
display will not illuminate and the drawer will remain off. The drawer can still be used
as a non-temp controlled drawer in this mode. When the refrigerator is taken out of
Sabbath mode, the Temperature Adjustable Cold Zone Drawer will have to be turned
back on.
NOTE
If the Temperature Adjustable Cold Zone drawer is not turned off prior to putting the
unit into Sabbath Mode, it will continue to adjust itself to maintain the set point even if
the display does not illuminate to show that it is still on.
Once both doors are in place, ensure they are aligned with each other and level (please
see the “Installation” section for more details), and replace the top hinge cover.
CAUTION
Be sure doors are set aside in a secure position where they cannot fall and cause
personal injury, or damage to the doors or handles.
To remove the refrigerator
doors:
1 Trace lightly
around the door’s
top hinges with a
pencil. This makes
reinstallation easier.
2 Disconnect the
harness by grasping
both sides of the
connector fi rmly, depress the latch, and pull apart. Remove the two (2) screws
from the top hinge. Lift the door off of the bottom hinge and set it aside.
3 Unscrew the three (3) lower hinge screws and hinge if necessary.
To reinstall the right door, reverse the above steps.
Lower Hinge Removal
Getting through narrow spaces
If your refrigerator will not fi t through an entrance area, before
installing the door handles, you can remove the doors. Check
fi rst by measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord is unplugged
from the wall outlet.
2 Open the freezer drawer and remove the toe
grille (see “Installation” section).
3 Remove any food from the door shelves and
close the doors.
Removing Freezer Drawer
1 Open freezer drawer.
2 Remove drawer screws on right and left
sides (two (2) screws on each side).
3 Lift drawer up and out to remove.
Installing Freezer Drawer
1 With lower slides pulled out, hang drawer onto
slide brackets ensuring pins on each side are fully
inserted into slots on each side.
2 Reinstall four (4) drawer screws (two (2) per side),
tighten down, and close drawer (C).
3 Check gasket seal around top, bottom, and sides
of freezer drawer.
4 If gasket is not sealed, open drawer and slightly
loosen four (4) drawer screws (two (2) on each
side) to allow drawer to rotate.
5 Close drawer and recheck the seal on the
gasket (A). Open the drawer grabbing by the
sides in the center (B). Be careful not to rotate
the drawer.
6 Tighten four (4) drawer screws.
7 Recheck gasket seal.
8 Install the toe grille by fi tting into place.
CAUTION
Drawer is heavy. Use caution when lifting.
Pull Drawer Out
From Both Sides
Grab Drawer
At Center
Then
Push Against
Freezer Drawer
AB
Fully Extend
Assembly
Drawer Slides
Pin
Slot
Cabinet
Drawer
Install Hex
Head Drawer
Screws
Installing the Door Handles
1 There are 6 handle studs on the
refrigerator.
3 Tighten the set screw. There are 2 set
screws per handle assembly.
2 Slide handle endcaps over door stud.
4 Repeat with all 3 handle assemblies.
Setting cooling temperatures
Press the + or – indicator to adjust the temperature to the
desired setting. The temperature display will begin to
blink with the fi rst touch. The display will time out after 10
seconds and return to the basic display.
Alarms
Door Ajar If the door has been left open for an
extended period of time, an alarm will
sound and the door ajar indicator will
display on the bottom display of the
control panel. The alarm is turned off
by closing the door. The mute sounds
key will blink to prompt the reset of any
active alarms. Press this key to reset any
system alarms.
High Temp In the event of a high temperature
condition, the temperature display
will blink and display “HI”. After 20
minutes, the alarm will sound and the
high temp indicator will be red on the
bottom of the control panel. The mute
sounds icon will illuminate until pressed,
acknowledging the alarm, at which time
the highest temperature reached will
be displayed and the refrigerator will
resume normal operation. In case the
high temp alarm is not acknowledged at
the fi rst alarm sound time out, when the
door is fi rst opened, the alarm sound will
be repeated.
Power Fail In the event of a power failure, the
power fail alert will be displayed and
the temperature display will blink
until the mute sounds icon is pressed,
acknowledging the alarm. Other modes
may be turned off until the alarm is
acknowledged. The power fail alert
is turned off and the refrigerator will
resume normal operation. The high
temp alarm may also be illuminated until
a safe operating range temperature has
been reached.