Use and Care

28
USA
End of Program indicator will light up
when the washing program is over.
1. Open the door of the machine.
2. Press On/Off key to turn off your
machine.
3. Close the door.
C
For energy saving, the
machine is automatically
turned off following the
completion of the program or
if the program is not started.
C
Leave your dishes in the
machine for about 15
minutes to allow them cool
down after they are washed.
Your dishes will dry in a
shorter time if you leave
the door of your machine
ajar during this period. This
process will increase the
drying effectiveness of your
machine.
6.11 WATER CUT-OFF
WARNING
If main water supply is cut or water
inlet valve is turned off the machine
cannot take water in and E:02 icon will
flash on the program indicator. As long
as the problem continues, washing
program is paused and the water inlet
is checked regularly by the machine;
when the water is restored E:02 icon
will disappear after a while and the
washing program resumes.
6.12 OVERFLOWING
WARNING
If the machine intakes too much
water or there is leakage at any of the
components then the machine will
detect this and E:01 icon will flash on
the Program indicator. As long as the
overflowing continues safety measures
will become active and try to discharge
the water. If overflowing stops and
safety is assured, E:01 icon will
disappear. If E:01 does not disappear,
there is a permanent fault. In this
case the authorized service should be
contacted.