Installation Instructions

Grille Assembly -

Custom Panel Models

On Custom Panel models, grill spacers from original unit grilles must be reused:

• Remove grille brackets from grille included in the grille kit by removing 4 screws on each

grille bracket located on the back of the grille assembly.

• Remove grille brackets and spacers from original unit grilles by removing 4 screws on each

grille bracket located on the back of each grille assembly.

• Install grille brackets and spacers from original unit grilles onto grille from the kit using the

original grille hardware.

Important: The spacers must be oriented on the new grille the

same way they were on the original grille.

Also, remember to install the spacers on the

corresponding side of the installation (if installing a unit on the left side of an installation, its

grille spacers should be installed on the left side of the unified grille.)