Operation Manual

0478 201 9910 D - EN
38
Please always observe the following
important information for the prevention of
damage or excessive wear to your VIKING
machine:
1. Wearing parts
Some parts of the VIKING machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
–Blade
– Blade disc
2. Compliance with the information in
this instruction manual
The VIKING machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– Inadequately dimensioned power
cables (cross section)
– Incorrect electrical connection (voltage)
– Product modifications not approved by
VIKING
– Use of tools or accessories which are
not approved or suitable for the
machine, or are of inferior quality
– Improper use of the product
– Use of the product for sporting or
competitive events
– Resultant damage due to continued use
of the product with defective
components.
3. Maintenance operations
All operations listed in the section
"Maintenance" must be performed
regularly.
If these maintenance operations cannot be
carried out by the user, a specialist dealer
must be commissioned to perform them.
VIKING recommends that you have
maintenance operations and repairs
performed exclusively by a VIKING
specialist dealer.
VIKING specialist dealers regularly attend
training courses and are provided with
technical information.
If these operations are neglected, faults
may arise which are the responsibility of
the user.
These include:
– Damage to the motor as a result of
inadequate cleaning of the cooling air
guide (inlet slots, cooling ribs, fan
wheel)
– Corrosive and other resultant damage
caused by incorrect storage
– Damage to the machine through the
use of inferior-quality spare parts.
– Damage due to untimely or inadequate
maintenance or damage due to
maintenance or repair work not
performed in the workshops of
specialist dealers.
Blade:
6008 702 0121
Wing blade:
6007 702 0300
Blade disc assembly:
6007 700 5190
Shredding material should be
composted and not disposed of
in household waste.
The machine, its packaging and
accessories are all produced
from recyclable materials and must be
disposed of accordingly.
By disposing of materials separately, and
in an environmentally friendly manner,
valuable resources can be re-used. For
this reason, the machine should be
disposed of for recycling at the end of its
useful life.
We,
VIKING GmbH
Hans Peter Stihl-Strasse 5
A 6336 Langkampfen/Kufstein
declare that the machine,
Shredding machine for plant trimmings
with electric motor (GE)
conforms to the following EU guidelines:
2000/14/EC, 2011/65/EC, 2002/96/EC,
2004/108/EC, 2006/95/EC, 2006/42/EC
15. Standard spare parts
16. Environmental protection
17. CE - manufacturer's
declaration of conformity
Manufacturer's
brand:
VIKING
Type: GE 103.1
GE 105.1
Serial number 6007