Planning Guide

11
Island Installations
T
he cabinets can also be installed in an island format. If desired, a half-wall can be built at the back and side panels (SP30)
can be used to finish the sides. All the cabinets will be lined up flush at the face, or a 3-sided half-wall could be built to
eliminate the side panels.
Alternatively, islands can be finished with Viking produced back panels. There are individual panels made to fit each indi-
vidual cabinet offered by Viking. The result is a smooth, custom fit finish.
Example without oven cabinet ending run:
Example with oven cabinet:
As shown in the example below, there may be instances when an oven tower ends the island cabinet run. When this is the case, a
29
3
⁄4”W./68”H. side panel (VTSP30) will be used to end the run and a 30”W./34”H. half side panel (VTHP30) will be used on the side
of the oven tower cabinet that the countertop runs into. A 32”W./68”H. back panel (VTBP32) will also be used on the rear of the unit.
Example when refrigeration ends the run:
*Please note: If a VFLR4 is used in an island setting, a VBPFLR4 is used as the back panel.
VBBO1601VBO1830
VSP30
VBO1811VQBO3021VERO3200
VFLR4
VTSP30
VTBP32
VTHP30
VBPFLR4*
= COUNTERTOP
TOP VIEW
VSP30
VQWO3010
15"W. REF. PRODUCT SLIDES IN
VSP30
24"W. REF. PRODUCT SLIDES IN
VBBO1601
VBP32
VBP16
VBPFLR4* VBP30 VBP24
VURO3200
VURO2400
VFLR4
= COUNTERTOP
TOP VIEW
VQBO5322VBO1811
VSP30
VSP30
VSBO2402
VBP18
VBP53
VBP24
= COUNTERTOP
TOP VIEW
PLANNING YOUR VIKING OUTDOOR KITCHEN