Planning Guide

13
When to Use Inside and Outside Filler Strips Together (see sample drawing below)
In situations where the back of your cabinet layout is exposed, such as in an island setting, inside and outside filler strips
will need to be used. Use a 90° (VCF90) or 135° (VCF135) inside filler whenever you have a 90 or 135 degree turn.
Depending on which turn you are accounting for, a 90° (VOCF90) or 135° (VOCF135) outer corner back panel assembly
must be used to complete the layout. These assemblies consist of a 4”W. stainless steel “post”, two mounting brackets,
and two stainless steel back panels.
The post is placed in the middle corner of the void area (see diagram below) and the back panels are attached to it. The
post gives support to the void area underneath the countertop that falls in between the cabinets. Next, the supplied
brackets are attached to the inside of the two adjacent cabinets in the run. The stainless steel back panels are then
attached to the brackets and fit flush with the back panels attached to the back of the cabinets to the right and left of the
center post.
VBBO1601
VSP30
VBP18
VQBO3021
VCF90
VBP18
VBBO2602
VSP30
VOCF90
VBO1811
VBO1830
VBP16
VBPFLR4 VBP30 VOCF90 Back Panel
VOCF90 Back Panel
VBP26
VFLR4
= COUNTERTOP
TOP VIEW
PLANNING YOUR VIKING OUTDOOR KITCHEN