Installation Guide

33
IMPORTANT – Please Read and Follow!
DO NOT remove permanently affi xed labels, warnings, or plates from product. This may void the
warranty.
Please observe all local and national codes and ordinances. Installation must conform with local
codes and National Fuel Gas Code ANSIZ233.1/NFPA-54–latest edition.
Please ensure that this product is properly grounded.
The installer must leave these instructions with the consumer who should retain for local
inspector’s use and for future reference.
Installation must conform with local codes or, in the absence of codes, the National Electrical
Code, ANSI/NFPA 70-latest edition.
In Canada: Electrical installation must be in accordance with the current CSA C22.1 Canadian
Electrical Codes Part 1 and/or local codes.
WARNING
BURN HAZARD
The use of cabinets for storage
above the appliance may result
in potential burn hazard. Combustible items
may ignite, metallic items may become hot
and cause burns. If a cabinet storage is to
provided the risk can be reduced by installing
a range hood that projects horizontally a
minimum of 5" (12.7 cm) beyond the bottom
of the cabinets.
WARNING
ELECTRICAL GROUNDING
INSTRUCTIONS
This cooktop must be electrically
grounded in accordance with local codes
or, in the absence of codes, with the
National Electrical Code, ANSI/NFPA 70-
latest edition. FOR PERSONAL SAFETY,
THIS APPLIANCE MUST BE PROPERLY
GROUNDED.
WARNING
The power supply board is provided with
the power supply, type RAC03-24SC/277,
manufactured by Recom, rated Input 100-
277Vac, Output 24V/125mA is UL recognized
under QAQGQ2/8.E224736. The external
overcurrent protection of the primary for this
power supply is max.20A.
WARNING
The electrical power to the unit must
be shut off while line connections are
being made. Failure to do so could
result in serious injury or death.
WARNING
FIRE AND ELECTRICAL
SHOCK HAZARD
DO NOT use an extension cord with
this appliance. Such use may result
in re, electrical shock, or other
personal injury.
CAUTION
Be sure the electric power is
off from the breaker box to the
junction box until the cooktop is
installed and ready to operate. The junction
box should be connected to a suitable ground.
WARNING
Stationary appliances not tted with means
for disconnection from the supply mains
having a contact separation in all poles that
provide full disconnection under overvoltage
category III, the insrtuctions shall state
that means for disconnection must be
incorporated in the xed wiring in accordance
with the wiring rules.