Outdoor Kitchen Planning Guide

Outdoor

Planning Your Viking Outdoor Kitchen

Note: If a VFLR4 is used in an island setting, a VBPFLR4 is used as the back panel.

INSTALLATIONS REQUIRE A 4”W. FILLER STRIP

There are several situations where 4”W. back panel (VBPFLR4) and back panels need to be used. The VLFR4 is a

4”W., 34-11/42”H. (includes 4-11/42” toe kick area) stainless steel “post” sandwiched between two cabinets.

1. Use a 4”W. ller whenever two Viking appliances are installed side-by-side in the run. This will give the appliances

ample room for any clearance issues they may have in their general specications. Remember that 8” is required for

proper installation of the rotisserie motor on a grill.

2. Use a 4”W. back panel whenever a Viking outdoor grill is used in a layout against a non-combustible surface (such

as a brick wall). The general specications for the grill require 3” of space between the back of the grill and any non-

combustible surface. The 4”W. back panel accounts for this. (See sample drawing on page 9)

3. If a VFLR4 is used in an island setting, a VBPFLR4 is used as the back panel.

4. Use the 4”W. ller whenever extra room in your cabinet layout is desired.

INSTALLATIONS REQUIRING 90° AND 135° INNER AND OUTER FILLER STRIP

Many installations include a “turn” in the layout. These turns can folloW. a back wall, or they may exist in an island

setting. If a layout such as this is designed, 90 or 135 degree ller strips will need to be used. IMPORTANT: When

using a VCF90, do not install a warming drawer base cabinet directly adjacent to a VBO1830 or VTPO1810. The

cabinet drawers will not be allowed to fully extend due to the warming drawer handle.

WHEN TO USE INSIDE FILLER STRIPS BY THEMSELVES

(SEE SAMPLE DRAWING BELOW)

Use a 90° (VCF90) or 135° (VCF135) inside filler whenever you have a 90 or 135 degree turn. If the layout is against

a wall, no outer corner ller will be needed. The countertop will run into the wall. Your locally-supplied countertop

installer will need to account for the void area underneath the countertop that falls in between the cabinets.

VBBO1601

VSP30

NON-COMBUSTIBLE SURFACE

VQBO4121

VCF90

VBBO2602

VTSP30

VBO1811

VFLR4

NON-COMBUSTIBLE SURFACE

VBPFLR4

(stainless facing out)

VBPFLR4

(stainless facing out)