Technical data

4. SYSTEM PROGRAMMING WITH PC SOFTWARE

To use the monitoring receiver with monitoring PC connect the mini USB port of receiver

to the USB port of the monitoring PC. Driver installation is automatic (from Windows 7).

After this the appropriate monitoring software settings should be done (it means usually

the serial port and baud rate settings).

The process is the following in AlarmSyS monitoring software:

Start Alarm Start software → Start Alarm Setup and log in (ID: 1, Password: 1) → Setup

menu → Hardware Setup → Digital Receiver #1.

In pop-up window basically only Receive and process incoming messages option

should be enabled, then set the proper COM port (checking in Windows OS: Control

Panel / Hardware / Device Manager) and Baud Rate to 57600, then apply changes.

After this receiver events are displayed on monitoring software screen.

Note: To connect IP2 card to monitoring software set Baud Rate value to 57600 in

monitoring software settings.