Technical data

In normal case programming of the monitoring receiver unit can be done through USB
(serial) port. After completing appropriate IP settings programming can be done through
Ethernet network as well. Please use EniTerm software for programming. The
programming steps are bellow:
1. Please start EniTerm software.
2. Choose the ET (settings) file according to the device what you want to program:
- IP.et – IP2 Ethernet receiver card programming
3. In Communication / Port Settings menu set the communication port / IP address for
programming.
4. With Communication / Read Data menu you can read stored settings from receiver.
The highlighted firmware version means
the following (hexadecimal format):
C – 12 (2012)
A – 10 (October)
02 – 2 (Second day)
5. Please execute the required settings in EniTerm software.
Note: The software functions are shown in EniTerm help menu.
7