Use and Care Manual

7
17621 South Susana Road, Rancho Dominguez, California 90221
[e-mail]
TECHNICAL DATA
Model No. VT-12TSMD-2Z
Capacity 12 Bottles
Volume 40 liters
Voltage AC 110V
Frequency 60HZ
Input Power 130W
Power Consumption (kWh/24h) 1.5
Ambient Temperature 50°-80°F
Temperature Range 46°-65°F
Net Weight / Gross Weight 33.1 Lbs / 37.5 Lbs
Unit Size (W×H×D) 19.68” x 14.76” x 21.26”
Packing Size (W×H×D) 21.65” x 16.93” x 21.65”
*Note: This wine cooler is designed to store standard Bordeaux 750 ml bottles. Storing large and/or oddly shaped
bottles (including champagne and sparkling wine bottles) will decrease the capacity of your wine cooler.
INSTALLATION INSTRUCTIONS
• Remove all packing material before using your cooler. Check to be sure
all parts are included and that the cooler is in good condition.
• Clean the interior surface with lukewarm water using a soft cloth before
first use.
• Position the cooler in a dry and airy place. The recommended ambient
temperature should be between 50° and 80°F.
• Place your cooler on a solid, level surface (other than carpet). This will
ensure vibration and noise-free operation.
• When positioning the cooler, 6 inches of space at the back and 10-12
inches of space both sides are suggested to ensure proper air circulation
to cool the cooling system. There also must be unlimited clearance at the
top of the cooler to ensure proper air circulation.
• Upon plugging the cooler into an electrical outlet, let the unit run for at
least 30 minutes before making any adjustments.
• This wine cooler uses thermoelectric refrigeration technology (no
compressor) and is not designed for storage in hot areas like garages,
warehouses or outdoors since it is designed to operate at a maximum of
30 degrees below the ambient temperature.
• The unit is designed for freestanding installation only. It is not designed
to be installed under a counter, inside a cabinet, or in any location that
does not allow the proper clearances on all sides, as stated above.