Operating instructions

WWW.VINOTEMP.COM
INSTALLATION INSTRUCTIONS
Before using your wine cellar:
• Remove any exterior and interior packing material.
• Check to be sure the following parts ar included:
o For 18-Bottle Wine Cellar, 5 slide out shelves.
o 1 instruction manual.
• Before connecting the appliance to the wer source, let it stand upright for
approximately 12 hours. This will reduce the possibility of a malfunction in the
cooling system
• Place your ap e appliance
when it is fully loaded.
front legs at the bottom of the appliance.
direct sunlight and
t sunlight may affect the
onsumption. Several
t rear for proper air circulation.
nt
below
e
sement installs.
ior light is on
or off or whether the bottles are located on the upper/middle or lower section.
Close the cel o the inside
temperature w
e
po
from handling during transportation.
pliance on a floor that is strong enough to support th
• To level your appliance, adjust the
• Designed for freestanding installation only, away from
sources of heat (stove, heater, radiator, etc.). Direc
acrylic coating and heat sources may increase electrical c
n e i ch s clearance must be given a
• Clean the interior surface with lukewarm water using a soft cloth.
OPERATING YOUR WINE COOLER
It is recommended that you install the wine cellar in a place where the ambie
temperature is between 50-80°F. If the ambient temperature is above or
recommended temperature, the performance of the unit may be affected. Placing in
extreme cold or hot conditions may cause interior temperature to fluctuate. Th
range of 54-66°F may not be reached. Not intended for garage or ba
The temperature may fluctuate depending on whether or not the inter
lar door immediately after putting in any items s
ill not rise dramatically.
How to use the buttons on the Display Panel:
You can set the temperature by pushing the control buttons.
There are two buttons on the panel “ + ” and “ - ” to adjust the temperature by 1°F
increments from 54-66°F. You can turn the interior light on or off by pressing the
light button.