Installation Guide

17631 South Susana Rd., Rancho Dominguez, CA 90221 U.S.A.
Toll Free: 800.777.8466 FAX: [phone] [e-mail]
www.Vinotemp.com
Connect the CO2 Supply
Line to the Regulator
by pushing it into the
side hole. To remove
it later on - simply
push in the ring.
ASSEMBLY
1.
2.
Screw the Tap Handle into the beer dispenser
Install the Top Part of the Regulator Adaptor into the CO2 regulator turning it
until it is well-tightened
Insert a CO2 Cylinder into the bottom of the Regulator Adaptor
5.
4.
Tighten the Regulator until you hear a click
Place the assembly
into the Support Stand
and position the
drip tray.
Turn the CO2 Regulator
completely "OFF" by
tightening using a
counter clockwise
movement
7.
9.
Position a
Drip Tray
The gauge should read
0.5 bars. If it does not
- adjust it using the
CO2 Regulator
8.
3.
6.