Owner’s Guide for the 200 MAX and 220 MAX models (Rev C) Recreationnal Vehicle Security System
[Table of contents] Your Warranty................................................................ 1 What’s included.............................................................. 2 System maintenance....................................................... 2 Transmitter Functions .................................................... Arming the system ...................................................... Disarming the system .................................................. High security disarm ...............
Limited Lifetime warranty: Models 200/220MAX Directed Electronics, Inc. (Canada) promises to the original purchaser to repair or replace with a comparable reconditioned model any DEI unit (hereafter the “unit”), which proves to be defective in workmanship or material under reasonable use during the lifetime of the vehicle provided that the unit was professionally installed and serviced by an authorised DEI dealer.
[ What’s included ] • • • • • • One control module A pair of four-button remote transmitters A Stinger® DoubleGuard® shock sensor (for motorcycle only) A push-button Valet® switch A mercury tilt switch (for motorcycle only) An electronic tilt motion sensor (included for ATV/snowmobile and optional for motorcycle) • A Fail-Safe® Starter Kill • A back-up battery siren • A Validation Certificat request form (Must be filled out and returned with a copy of the invoice to DEI) • HF+ external/receiver antenna
[ Transmitter Functions ] Model Arming the #473V system You can activate, or arm, the system by pressing on your transmitter for one second. When the system arms, you will hear a short siren sound, or chirp, and the brake light will flash once (If installed). Disarming the system To disarm the system press . You will hear two chirps, and the brake light will flash twice (If installed).
Disarming without a transmitter This feature allows you to disarm the security system without the remote transmitter should it be lost, damaged or disabled. In order to disarm the system without the transmitter, you must have the vehicle’s ignition key and know where the Valet button is located. To disarm the security system, turn the ignition to the “ON” position. Press the Valet button the preset number of times (one to five times) within 15 seconds. After 5 seconds, the system will now disarm.
Panic Mode If you are threatened near your recreationnal vehicle, you can attract attention by triggering the system with the remote transmitter. Just press for 2.5 seconds, and you will enter Panic Mode. The siren will sound and the brake light will flash (If installed) for the programmed siren duration. to stop Panic Mode at any time, press on the remote transmitter again. Silent Mode To temporarily turn off the arm or disarm chirps, use the Slent Mode.
[ Protection Features ] Mercury tilt switch : This detector is for motorcycles only. It is used to trigger the alarm if the motorcycle is raised off the side stand. Electronic tilt motion sensor: This sensor is used with ATV ‘s and snowmobiles sytems, but is sold as an option with motorcycles systems. When arming the system, the detector reads the position of the vehicle and won’t allow a motion of more than three degrees. Even if it is pushed forwards or backwards, it will trigger the alarm.
The Company behind Merlin recreationnal vehicle security systems is Directed Electronics, Inc. Visit our website at www.directed.ca Since it’s inception, Directed Electronics has had one purpose, to provide consumer’s with the finest vehicle security and car audio products and accessories. The recipient of nearly 100 patents and Innovations Awards in the field of advanced electronic technology, Directed Electronics is ISO 9001 and QC 9000 registered.
