Owner's Manual

ManualsBrandsViper ManualsAutomotive9211VL

Contents

Responder One .................................................................................................3

Basic Commands ..............................................................................................4

Remote Start ............................................................................................. 4

Unlock .....................................................................................................4

Shut Off the Remote Start ...........................................................................5

Remote Control Configuration .............................................................................6

Remote Pairing .........................................................................................6

Remote Start Features ........................................................................................7

Disabling Remote Start ..............................................................................7

Remote and System Operations ..........................................................................8

Out of Range ...........................................................................................8

Battery Information ....................................................................................8

Battery Replacement ..................................................................................9

Government Regulations ..................................................................................10

Warning! Safety First .......................................................................................11

Limited Lifetime Consumer Warranty ..................................................................13

9211VL 2012-07-11

Summary of content (14 pages)

PAGE 1
Contents Responder One..................................................................................................3 Basic Commands...............................................................................................4 Remote Start..............................................................................................4 Unlock......................................................................................................4 Shut Off the Remote Start...................................
PAGE 2
PAGE 3
Responder One Internal Antenna Transmit LED 1 Internal Antenna Transmit LED Feature Description Internal Antenna Used for transmitting and receiving information 1 Transmit LED flashes once when transmitting and receiving information. Transmit LED 1 1 1 Remote Start Internal Shut down Remote Start Antenna Unlock Press for one second to activate remote start. Press and hold for 3 seconds to deactivate the remote start. Transmit LED (Will only work if remote Press for one second to unlock.
PAGE 4
Basic Commands Remote Start Press and release the button. Activates the remote starter. The remote responds with the remote start On tone and the green LED on the remote flashes once. The vehicle's parking lights turn ON constant to confirm remote start signal has been received. The runtime on the remote starter is predetermined based on vehicle application. The remote starter will shut down when the preset runtime times out or when any shutdown zone becomes active.
PAGE 5
Shut Off the Remote Start Press and hold the button for 3 seconds. The vehicle shuts down from the remote start mode. The remote plays the remote start shut off tone and the orange LED flashes 1 time. The remote starter will also shut down when the preset runtime times out or when any shutdown zone becomes active. Note Refer to the Quick Reference Guide for more information. © 2012 Directed. All rights reserved.
PAGE 6
Remote Control Configuration Remote Pairing The following instructions will step you through the remote pairing operation. 1. Press and release the Integrated Programming Button (IPB) on the XL202. 2. Within 5 seconds, press and hold the IPB. The status LED will flash one time to confirm the system is ready for remote pairing. 3. Press the button, the remote will emit several tones to confirm pairing is complete. 4. Release the IPB.
PAGE 7
Remote Start Features Refer to the Quick Reference Guide for more information on remote start features that are specific to each vehicle. Disabling Remote Start Remote start can be disabled by moving the Toggle Switch to the Off position. If remote start is attempted while Off, the engine will not start. Move the switch back to the On position to resume normal operation. Note Consult the installation center for the location of Toggle switch. © 2012 Directed. All rights reserved.
PAGE 8
Remote and System Operations Out of Range Each time a command is performed the Responder One will expect a command confirmation from the system. If a command confirmation is not received a long fault tone plays as an alert. Battery Information Your remote is powered by two CR2016 cell batteries. When the batteries weakens, the LED on the remote dims and operating range is reduced. 8 © 2012 Directed. All rights reserved.
PAGE 9
Front Elastomer contact Battery Replacement 1. Using a small slotted screwdriver, inFront sert into slot located on the side of the unit as shown and carefully pry the Elastomer front of the contact unit up, working yourElastomer way around the edge contact until the front is completely separated from the housing. Circuit Board Front Front Elastomer Note: Make sure that the small elastomer con-contact Elastomer tact located inside the unit as shown does not fall out during the replacement process.
PAGE 10
Government Regulations This device complies with Part 15 of FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 11
Warning! Safety First The following safety warnings must be observed at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. When properly installed, this system can start the vehicle via a command signal from the remote control transmitter. Therefore, never operate the system in an enclosed area or partially enclosed area without ventilation (such as a garage).
PAGE 12
This product is designed for fuel injected, automatic transmission vehicles only. Use of this product in a standard transmission vehicle is dangerous and contrary the product's intended use. 12 © 2012 Directed. All rights reserved.
PAGE 13
Limited Lifetime Consumer Warranty Directed Electronics.
PAGE 14
REINSTALLATION OF THE UNIT OR ANY CONSEQUENTIAL DAMAGES OF ANY KIND. IN THE EVENT OF A CLAIM OR A DISPUTE INVOLVING DIRECTED OR ITS SUBSIDIARY, THE VENUE SHALL BE SAN DIEGO COUNTY IN THE STATE OF CALIFORNIA. CALIFORNIA STATE LAWS AND APPLICABLE FEDERAL LAWS SHALL APPLY AND GOVERN THE DISPUTE. THE MAXIMUM RECOVERY UNDER ANY CLAIM AGAINST DIRECTED SHALL BE STRICTLY LIMITED TO THE AUTHORIZED DIRECTED DEALER’S PURCHASE PRICE OF THE UNIT.