Installation & Assembly

GLD Products Ion Dartboard
Item 42-0003
9 1-800-225-7593
www.gldproducts.com
If batteries are installed when the external power supply is plugged in, the dartboard turns
off. To turn the dartboard back on, remove the batteries and the power cord. Plug either the
power cord OR the batteries into the dartboard.
CAUTION: The power adapter is not a battery charging device.
Do not plug in the power adapter when the dartboard is
turned on.
Remove all the batteries before plugging in the power
supply.
1. The board is not intended for children under the age of 12 years old.
2. The board must only be used with the recommended transformer.
3. The transformer is not a toy.
4. Disconnect the dartboard from the transformer before cleaning.
PROTECTIVE FILM
This electronic dartboard has a clear protective ! lm over the entire display and button
area to prevent scratching during shipping. It is recommended that you remove this ! lm for
easier reading of the display. To remove, simply lift edge, peel off and discard.
WARNING: Not for use by children without adult supervision.
Darts are not toys and may cause injury if used
improperly. Everyone must stand behind the dart
thrower.
IMPORTANT NOTES
1. During shipping or in the course of normal play, it is possible for scoring segments of this
board to become temporarily jammed, resulting in a “frozen” board. If this occurs, the built-
in Self Diagnostic Function of the e-BOARD Computer will be activated automatically.
Your dartboard will run a self-test routine to determine which segment is stuck. An error
message will " ash on the display together with the number for the “Frozen” segment.
a. Find the “frozen” segment according to the display.
b. Press ! rmly down on the “frozen” segment until it breaks free and the loose ! t is
restored. Once the “frozen” segments are loosened, the error message should be
gone and the board will continue to operate normally.