Mounting Instructions INSTRUCTIONS FOR MOUNTING DARTBOARDS AND CABINETS Replacement Parts Order direct at www.gldproducts.
GLD Products Mounting Instructions MOUNTING THE DARTBOARD CABINET Space Needed The dartboard cabinet must be securely mounted and must be at a right angle to the floor. The player throws a dart from a distance of 96 inches (244 cm) for a soft tipped dart and 93.25 inches (237 cm) for a steel tipped dart from the face of the dartboard. Allow room for players to stand. Depending on the players’ accuracy, allow room around the dartboard for missed throws. Refer to the mounting dimensions illustration below.
GLD Products Mounting Instructions To Mount a Cabinet for an Electronic Dartboard: 1. Lay the cabinet face up on a table or floor. Place your dartboard inside the cabinet and center it to your satisfaction. 2. Measure to find the side-to-side center of the dartboard. Also measure from the inside bottom of the cabinet to the center of the bullseye. Record these measurements: Side-to-side:____________ Vertical measurement to center of dartboard:__________ 3.
GLD Products Mounting Instructions To Mount a Cabinet for Bristle Dartboard: The bristle dartboard comes with a mounting clip. 1. Locate the center of the cabinet. There should be holes predrilled to secure the mounting clip. 2. Hold the clip in place over the screw holes. 3. Place a mark on the cabinet at the bottom of the slot of the mounting clip. This is the center of the bullseye. 4. Before marking or drilling holes in the wall, locate any wall studs that can be used to mount the cabinet.
GLD Products Mounting Instructions MOUNTING THE DARTBOARD Space Needed The dartboard cabinet must be securely mounted and must be at a right angle to the floor. The player throws a dart from a distance of 96 inches (244 cm) for a soft tipped dart and 93.25 inches (237 cm) for a steel tipped dart from the face of the dartboard. Allow room for players to stand. Depending on the players’ accuracy, allow room around the dartboard for missed throws. Refer to Mounting Dimensions illustration on page 2.
GLD Products Mounting Instructions To Mount a Bristle Dartboard: 1. Place a mark on the wall or mounting surface that represents the center of the bullseye, 68 inches (173 cm) above the floor. If you are mounting a cabinet in which the dartboard will be mounted, the cabinet may have the center marked. Follow the cabinet manufacturers instructions for mounting the cabinet to the wall. Then proceed with the steps to mount the dartboard. 2. Step 2. Review the parts that came with your dartboard.
GLD Products Mounting Instructions TO MOUNT A BACKBOARD The backboard will have eight holes pre-drilled into it. The four interior holes are for the dartboard bracket (you will only use two). The four exterior holes (mounting holes) are for securing the backboard to your wall (see illustration). The backboard comes with the dartboard bracket assembled to hang in the diamond position.
PROUD MANUFACTURER OF S84 W19093 Enterprise Drive • Muskego, WI 53150 USA 262.679.8730 or 1.800.225.7593 tele 262.679.8738 or 1.800.841.6944 fax Email: gld@gldmfg.com www.gldproducts.
www.gldproducts.