Installation & Assembly

GLD Products Mounting Instructions
3 1-800-225-7593
www.gldproducts.com
To Mount a Cabinet for an Electronic Dartboard:
1. Lay the cabinet face up on a table or oor. Place your dartboard inside the cabinet and
center it to your satisfaction.
2. Measure to nd the side-to-side center of the dartboard. Also measure from the inside
bottom of the cabinet to the center of the bullseye. Record these measurements:
Side-to-side:____________ Vertical measurement to center of dartboard:__________
3. Remove the dartboard and use the measurements to locate what will be the center of
the bullseye. Place a mark on the cabinet at this location.
4. Before marking or drilling holes in the wall, locate any wall studs that can be used to
mount the cabinet. The cabinet should be screwed into wall studs to provide the most
secure mounting. Do not use wall anchors if securing to wall studs. If wall studs will not
be used, be certain to use the correct anchors for your wall.
5. Hold the cabinet in a level position on the wall. Pre-drilled holes in the four corners of
the cabinet should line up with the wall studs (16 inches apart). Use a tape measure to
place the center mark that you made in step 3, 68 inches (173 mm) above the oor. Use
the screw holes as a template to mark the wall for the screw holes. Remove the cabinet.
If wall studs are not accessible, use the marks to drill four holes for the wall anchors.
Use the appropriate anchors and secure them in the wall.
6. Hold the cabinet in place and secure to the wall with screws. The cabinet should be
level and the cabinet doors should open and close properly.
7. Mount your dartboard according to the instructions provided with the dartboard.