Installation & Assembly

GLD Products Mounting Instructions
5 1-800-225-7593
www.gldproducts.com
MOUNTING THE DARTBOARD
Space Needed
The dartboard cabinet must be securely mounted and must be at a right angle to the oor.
The player throws a dart from a distance of 96 inches (244 cm) for a soft tipped dart and
93.25 inches (237 cm) for a steel tipped dart from the face of the dartboard. Allow room for
players to stand. Depending on the players’ accuracy, allow room around the dartboard for
missed throws. Refer to Mounting Dimensions illustration on page 2.
The dartboard can be mounted inside a cabinet or directly to a wall. Screw to a wall stud or
use anchors. The center of the bullseye should be 68 inches (173 cm) above the oor. Note
that wall thicknesses will vary. Use the correct anchors.
To Mount an Electronic Dartboard:
1. Place a mark on the wall or mounting surface that represents the center of the
bullseye, 68 inches (173 cm) above the oor. If you are mounting a cabinet in which the
dartboard will be mounted, the cabinet may have the center marked. Follow the cabinet
manufacturers instructions for mounting the cabinet to the wall. Then proceed with the
steps to mount the dartboard.
2. Step 2. Review the parts that came with your dartboard. Your parts should include:
• the dartboard,
• screws to secure the dartboard to the wall or cabinet.
3. Before marking or drilling holes in the wall, locate any wall studs that can be used for
mounting. The dartboard should be screwed into wall studs to provide the most secure
mounting. Do not use wall anchors if securing to wall studs. If wall studs will not be
used, be certain to use the correct anchors for your wall.
4. Hold the dartboard in a level position on the wall. Pre-drilled holes on one side of the
dartboard should line up with a wall stud. Use a tape measure to placethe bullseye over
the center mark that you made in step 1, 68 inches (173 mm) above the oor. Use the
screw holes as a template to mark the wall for the screw holes. If wall studs are not
accessible, use the marks to drill four holes for the wall anchors. Use the appropriate
anchors and secure them in the wall.
5. Hold the dartboard in place and secure to the wall with screws.