Installation & Assembly

GLD Products Mounting Instructions

61-800-225-7593

www.gldproducts.com

To Mount a Bristle Dartboard:

1. Place a mark on the wall or mounting surface that represents the center of the

bullseye, 68 inches (173 cm) above the oor. If you are mounting a cabinet in which the

dartboard will be mounted, the cabinet may have the center marked. Follow the cabinet

manufacturers instructions for mounting the cabinet to the wall. Then proceed with the

steps to mount the dartboard.

2. Step 2. Review the parts that came with your dartboard. Your parts should include:

• the dartboard,

• a mounting bracket and screws to secure the mounting bracket to the wall or

cabinet.

• spacers and screws or nails to secure the spacers to the dartboard.

• a single mounting screw that goes into the center of the dartboard to hang the

dartboard on the mounting bracket.

3. If your dartboard is mounting directly to a wall, mount the bracket to a stud for secure

installation. If it is not possible to mount to a stud, use the appropriate wall anchors to

secure the mounting bracket to the wall. The bottom of the slot on the mounting bracket

should line up with your mark for the bullseye (step 1). The slot on the mounting bracket

should open upward.

4. The spacers in your packet will keep your dartboard parallel to the wall. Position the

spacers evenly (the dartboard may have predrilled holes) around the outside edge of

the board. Keep the spacers near the edge and secure with nails or screws provided.

5. The back of the dartboard will have a mark or small hole in the center of the dartboard.

Turn the mounting screw into the mark. Tighten but leave a small gap between the

screw head and the board. The gap will allow the screw head to slip easily inside the

slot of the mounting bracket. You need to adjust the tightness of the screw to create a

snug t in Step 6.

6. Hang the dartboard in the mounting bracket by sliding the screw head into the slot on

the bracket. The dartboard will be loose on the wall. Remove the dartboard and screw

the center screw in 1/2-turn. Hang the dartboard. Check the looseness. Repeat these

steps as needed until the dartboard hangs with no looseness. The number 20 should be

at the top.

Mounting Bracket

Center of Bullse

Side view

Dartboard

with

Mounting

Screw