Installation Sheet

ASSEMBLY INSTRUCTIONS

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A

LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN

FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS

ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL.

ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

1. Carefully remove all parts from the carton.

2. Remove the white plastic bushing from the threaded hole of light ﬁxture (K).

3. Screw the bottom nipple of lamp pole (J) into the top opening of light ﬁxture (K).

4. Screw connective tube (H) onto the top nipple of lamp pole (J).

5. Screw the bottom nipple of lamp pole (G) into top opening of connective tube (H)

6. Feed wire through pole (J), connective tube (H), pole (G), mounting loop (D)

and come out from the back side of canopy (E).

7. Unscrewing canopy ring (F), slide canopy (E) and canopy ring (F) on pole (G).

8. Attach mounting strap (A) to ceiling outlet box and secure with mounting

screws (B).

9. Insert top thread nipple (C) in mounting strap (A).

10. Attach mounting loop (D) to thread nipple (C).

11. Attach the bare copper ground from the ﬁxture to the ground junction box

wire (usually green or copper), fasten together with a plastic wire connector.

Tighten wrap the wire connector with electrical tape. Be sure no wire strands

are exposed.

IT IS IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE

PROPERLY GROUNDED.

12. Connect neutral wire from ﬁxture (ridges molded wire) to the neutral wire from

the junction box (usually white) . Fasten both wires together with a plastic wire

connector and tightly wrap the wire conncetor with electrical tape. Be sure no

wire strands are exposed.

DRY

Sommerard Triple Arm Chandelier

Item # ARN5009

PAGE 1
Sommerard Triple Arm Chandelier Item # ARN5009 ASSEMBLY INSTRUCTIONS WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. B C A E D F G ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. 1. Carefully remove all parts from the carton. 2.
PAGE 2
Sommerard Triple Arm Chandelier Item # ARN5009 ASSEMBLY INSTRUCTIONS WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. B C A E D F ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED. 13.
PAGE 3
Clarkson Triple Chandelier Item # ARN5009 UNPACKING NOTICE DUE TO THE SCALE, WEIGHT, AND PIVOTING FUNCTION OF THIS DESIGN, ITEM MUST BE HANDLED WITH CARE TO AVOID POTENTIAL DAMAGES. A EQ 1. Two persons are recommended for this install. 1. Pivoting arms (A) allow direction of light to be positioned as needed. 2. Rotate triple arm position with equal distance (B) for proper balance during installation. B ABOVE VIEW 22008 N. Berwick Drive | Houston. TX 77095 | 713.686.5999 tel | 713.686.