Installation Sheet

1. Carefully remove all parts from the box.
2. Install the crossbar (B) with ceiling loop (D) to the outlet box by mounting screws
(C) provided.
3. Thread the top leaf (H) to the thread nipple (I).
4. Unscrew the threaded collar on the chain end link (G) and attach it to the top ring (H1).
Close the threaded collar to secure the fixture body.
5. Let canopy (E) and lock collar (F) go through the chain (L).
6. With the fixture dimension as a guide, shorten the chain (L) as needed using a pair
of chain pliers.
7. Unscrew the threaded collar on the other chain end link, raise the fixture then attach
chain end link to the ceiling loop (D). Close the threaded collar to secure.
8. Unwrap the wiring from the top of the fixture body. Weave the power supply cord and
the ground wire through the chain (L).
9. When you reach the canopy and ceiling loop, measure the wires then cut. Be certain
to leave enough to connect inside of the outlet box.
10. Strip the insulation back on the two power supply wires about 5/8".
11. Twist the power supply and ground wire together and push through the center hole of
the ceiling loop (D).
Gramercy Medium Ring Chandelier
Item # CHC 5377
WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A
LICENSED ELECTRICIAN.
WARNING***SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN
FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION.
INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY
DAMAGE OR OBVIOUS DEFECT. DO NOT INSTALL.
ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
NOTE: CAREFULLY UNPACK EACH PIECE IN TOP LAYER OF PACKING PRIOR TO
REMOVING. RETAIN ALL PACKING MATERIALLY UNTIL INSPECTION AND
INSTALLATION ARE FINAL.
DRY